It lags badly even on edit mode when I try to place all the controls I need. I know how to get references of this controls, and how to acces them all programatically, but my problem is that there is just to many of them for Laview to run with no lag. I Want to create an application wich will have to handle a lot of controls on it. Try something else to get MAX 5.0 working? Install MAX 5.1? I don't have many other options since some of my software uses Traditional NI-DAQ. I take this as a sign that not seeing software within MAX is at the root of my problem.Īlso, the "Tools" -> "Reset Configuration Data" option is not there although it is supposed to be in MAX 5.0Īs far as I can tell everything I am using is compatible. If from within MAX I try "Tools" -> "NI-VISA" -> "VISA Options" nothing happens. Note: My system includes an 8 port serial card and while the ports do list under the MAX hardware section (COM3-COM10) it seems like my software can only access COM1 and COM2. When I am done MAX does not list any software. My hardware shows up fine. Since this system has been in use for over a decade I also thought loading from scratch would be a good idea. I am loading a hard drive from scratch since the old system used a PATA drive and the new system uses a SATA drive. I am upgrading a very old test system to a new motherboard. I`m searching but at this moment I found nothing ^^ I would like to know what you`re thinking about that. I have two ideas to delete this parasite point, but I don`t know which one is the best and how to do.ġ) I could compare the point before and the point after, and if the point between both of them is to different, LabVIEW delete it.Ģ) I could put one threshold, I mean if the value is more or less than the point before more or less 20 pixel, so this point is delete. Labview send my each coordinate of my object for each frame of the video. So as you can see, I should not have this straight line. It happens not often, maybe twice with one video of 2 minutes (20FPS). I have to draw the deplacement of my objectand sometimes I have one parasite point, and unforthunately because of that the draw is not good. I`m trying to realize one tracking with LabVIEW Vision, It works not so bad, but sometime I have one problem. If I do need to put it in a while loop, which elements should I put in the loop?Īttached the part of the code in capture2.jpg I haven't put it in a while loop to figure out what happens when you run it once. I made a sample program but it keeps showing the error:Įrror -20315 occurred at Timing and Transition Measurements2->testflow.viĪnalysis: The waveform dt parameter is UI_2.viįor a square wave, it keeps showing some the frequency at "2500", and after 2-3 times of running, throws up the same error (20312) with "2147483647" in the same frequency display. I don't know what frequency the signal is at. To simulate the signal, I'm using InstaCal (virtual board from Measurement computing) to generate a sine wave of amplitude 5V. I have tried two methods and am facing different problems with them. I am very new to this and don't really know what the problem really is. My input is in the form of pulses with varying amplitude, and I need to be able to measure their frequency. I'm planning on using a MCC DAQ for measuring frequency through an analog port.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |